How to Use The Jade Facial Massage Tool

Does your skin look dull and tired? Instantly bring radiance back to your skin by  releasing tension held up in your face with this Jade Facial Massage Tool. The 6000 vibrations /min Jade Facial Massage Tool will work directly on releasing tension of your muscles. 

Benefits

Using the T-Bar Facial Sculpting Massage Tool benefits the skin in various ways. 

  1. It massages the face, which will stimulate blood flow. 
  2. Encourages drainage of lymphatic fluid. 
  3. Aids relaxation of tense muscles.
  4. It tightens the skin.
  5. Stimulates removal of dark circles underneath the eyes.
  6. Helps with removing old skin cells and keeps your skin smooth.
  7. Reduces fine lines and wrinkles.
  8. It helps remove build up of toxins and other stagnant molecules.

How to Use

Jade Facial Massage Tool recommended use it 5-10 min a day, with no more than 3-5 strokes at a time per area.

  1. Double cleans your skin
  2. Apply oil or moisturiser to your skin
  3. Gently place the round vibrating stone on various places of your face, without putting too much pressure.
  4. Do not place it directly on bone.
  5. Slowly move the vibrating end over your cheek from your nose towards your ear.
  6. Hold the vibrating stone on acupressure points for a couple of seconds.
  7. Gently allow the vibrating tool to loosen up areas of tension like the masseter muscle. 
  8. Rinse with water after use.

 

The On/Off Switch

The on/off switch is hidden at the end of the massage tool. Twist it to turn it on and off.

Battery Replacement 

The Tool does not come with Batteries, however you could be lucky and receive one with batteries. To replace the batteries follow the following steps:

  1. Twist counterclockwise until the bottom cover falls off

  2. Put in a AA battery



  3. Install switch cover clockwise



  4. Twist counterclockwise to turn on the machine

As an exception the Jade Facial Massage Tool is also known to twist off the top:

 

 

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.